SHUWA INDUSTRY

ENGINE PARTS

Pull Starters

There are 2 types of pull starters, small and large frame.
These will fit most Japanese made engines.

Shuwa was the biggest private label engine producer in Japan. If you own a "Made in Japan" engine that was not made by OS, Enya, Saito, or YS it was probably made by Shuwa Industry.

Shuwa private labeled or made engines for HPI, Yokomo, Fantom Racing FR, Kyosho, Tamiya, Air Supply AS, Team Infinity, Drake, Acme, Werks, Orion, Hot Bodies, and others.

Small Frame
Hole spacing is 1.065" or 27mm

Part Number S20-001
for small .05 engine with 11mm hex one way bearing

Part Number S20-002
for .12 - .28 engines with 14mm hex one way bearing and 1.15" rubber tube spacer between pull handle and starter body.

Part Number S20-003
for .12 - .28 engines with 14mm hex one way bearing, Same as S20-002 except 1.15" rubber tube spacer between pull handle and starter body.

NOTE: one-way clutch bearing not included

Click here for one-way bearing specs

Large Frame
Hole spacing is 1.220" or 31mm

Part Number S20-011
for .12 - .18 engines with 14mm hex one way bearing and 1.15" rubber tube spacer between pull handle and starter body.

 

NOTE: one-way clutch bearing not included

Click here for one-way bearing specs

Listed below are variations used on particular engines
They are the same as the large frame above
Large Frame used
on Kyosho 12-18
Large Frame used
on HPI 12
Large Frame used
on HPI 15
Large Frame used
on HPI 18


Return to SHUWA parts page

Shuwa Industry has been acquired by
MECOA - Model Engine Corporation of America
www.mecoa.com
1630 South California Ave
Monrovia, California 91016